Description: While the Dignitet curtain wire looks nice, it is not the most functional since it tends to sag (even when tensioned properly taut, it will. Buy IKEA – DIGNITET Curtain Wire, Stainless Steel: Window Hardware Sets no help at all, all you need is common sense, patience and follow the instructions. The items shown here are a Dignitet system from Ikea. .. else mentioned that, and it’s not that obvious from the instructions, but when you go to.
|Published (Last):||8 September 2004|
|PDF File Size:||14.95 Mb|
|ePub File Size:||11.65 Mb|
|Price:||Free* [*Free Regsitration Required]|
After your curtains are installed, you can tighten a bit more if you need to. Other systems are available. I had to bring in the big guns for this project as my own ‘power tool’ experience leans more towards sewing machines than drills. Thanks for posting this! Determine Your Layout We worked with a rather unusual layout.
Somewhere on the package it reads, “Easy dignktet cut. I plan to hang net curtains over a 4 metre length, so not very heavy, but when I bought the Dignitet in IKEA yesterday I noticed their display was very droopy nd have since read some comments online that it’s difficult to keep the cable taut. I guess it would probably work pretty well for its intended purpose, too. That being said, I love the over-all look vignitet my photo display; it will be very easy to change photos and artwork.
I’ve had a pile of this hardware for several years, given it heavy use in a variety of applications, and it still instructiobs and functions like brand new.
I understand you used two types of fasteners one type to set up and one type afterwards.
I’ve never been able to figure it out and have had to rely on the kindness of boyfriends to do it for me really, IKEA, would it be that hard to put WORDS with your picture-instructions?!? Once we laid out and positioned our posts, we replaced the expansion fasteners with a nylon fastener that expands behind the drywall for a more secure anchor, like the ones shown below. You might try looking on the packaging or on the IKEA site for that information.
However, the length of my entire display is only 28″. There’s going to be significant pull on the bases, and you don’t want your curtains sagging!
IKEA – DIGNITET Curtain Wire, Stainless Steel | Shabby Chic Shower Curtains
Threading and tightening the cable Insert and fasten one cable end into the anchor post. Victoria T – there is a special part you seat the cable into and they provide a special allen wrench to tighten the wire to create the tension.
Do you want curtains on either side or on three sides? So, we may not be the most valuable resource for whether or not it will eventually droop for you. Make the plum bob line about 12″ shorter than the ceiling height, tie on the weight, and get on the ladder.
Mila – as we mention above: Our bed was king-sized and set into a corner diagonally. Did you see the curtain tutorial?
I had already extended the post screw to its furthest position in order to be able to adjust and pull the cable tight. This mark will be the center of the post bracket. However, despite how I pulled the “rope” to tighten the slack, I just couldn’t level it out.
While tightening, keep an eye on the other posts. Posted by Carter Dale on Sunday, July 6, Complete installation of remaining posts. The instructions show how to do this, but it’s easy even if you don’t have instructions. This is the best idea so far Loosen the nuts on the right side, insert the wire, and tighten the tiny nuts again.
So, I asked my husband Bob who is always a good sport and really tall to bring his years of experience as a builder to the table to show you how to install this very cool cable wire system. Also, our curtain needed to go behind the headboard, because we wanted to hide the tubs and stuffed animals secreted away there.
Make sure the hole in the post where the cable goes is lined up in the same direction of the next post! You should make sure you are going into a joist, stud or moulding; if you try to just screw into drywall, I don’t think you’ll have much luck at all.
Installing Cable Wire for Hanging Curtains
Sewing Setup for Teens. If you’re used to putting things together yourself, this is a simple project.
It’s screwed to the wall. The hardest thing is positiong the wire plates at either wall exactly where you want them if no studs are present. My curtains are pretty heavy made from silk and lined -do you think it will hold them? If you can’t attach this to wall studs, you might just want to go with ceiling curtain rod brackets ad a very lightweight curtain rod all of which Ikea happens to have for a dignitdt, lot less than Home Depot.
Ikea dignitet how to install | iphoneography | Pinterest | Ikea, Ikea hack and Art for kids
It’s easy to get carried away and exert too much force on them. Place the bracket base with the center over the hole you just made. Skip to main content.