Manuals or user guides for your HP Jetdirect x OfficeConnect. Manuals or user guides for your HP Jetdirect x Print Server (3-pack). HP Jetdirect Print Server Administrator’s Guide (x, x). X – JetDirect Print Server Print Server pdf manual download. Also for: Jetdirect x.
|Published (Last):||18 November 2010|
|PDF File Size:||1.77 Mb|
|ePub File Size:||14.61 Mb|
|Price:||Free* [*Free Regsitration Required]|
HP 300X – JetDirect Print Server Administrator’s Manual
Note For incoming print path requests, the network administrator must configure the firewall to accept To allow additional networks at the HP site, the subnet mask of The item numbers in the following tablecorrespond to the callouts in Figure 6. It matches the product: For more information, see the bootpd man page. The firmware revision number of the HP Jetdirect print X.
For proper printing, print files must be in a language recognized by the printer such as Jetdirecy, PCL, or unformatted text. Moving to Another Network When moving an HP Jetdirect print server that is configured with an IP address to a new network, make sure that the IP address does not conflict with addresses on the new network.
Select Value, then Edit Array. LocalTalk is always enabled. The configuration information for individual networks is listed in the following tables: Total number of frames packets not successfullytransmitted because of errors.
Resolving Ejtdirect Display Error Messages Try to isolate the problem to either the printer or the print server. Make sure your users know the printer names for the printers, sincethey must type those names on the command line for printing.
Examples for BSD-based systems: This chapter describes ,anual to configure the HP Jetdirect print server for use with various systems that support LPD printing. This product cannot be identified by Serial Number alone. This product was sold by a reseller. Indicates that LAN Server was manuallydisabled through the printer’s control panel if available.
To enable, set to 1.
If other users are able to print, are they using the same networkoperating system? Select from the products you own. At the prompt, jftdirect Click OK and select Exit from the List menu.
Enables or disables the embedded jetdirwct server on the HPJetDirect print server. Instead of yourprinter remaining on the default zone, which is set by the router,this utility lets you select hpp zone on which your printer appears. This product has been exchanged for a new or refurbished product. For a three-portHP JetDirect external print server, the nameshould be raw1, raw2, or raw3 depending on theport to which the printer is attached. If the errorpersists, there is a problem with the HP JetDirect printserver.
Page 52 To set configuration parameters, you must set up a Telnetconnection from your system to the HP JetDirect print server. Please wait while we process your request.
Is the printer plugged in and turned on? Table Of Contents Manuak of Contents 1. Does the same error message appear on the printer? The HP JetDirect print server detected a break in the datacommunications.
HP Jetdirect x Print Server (3-pack) User Guides | HP® Customer Support
Assign an unused printer number. The arp command writes the entries to the arp cache on the workstation, and the ping command configures the IP address on the print server. Is your protocol enabled?
In addition, HP provides software for network configuration on the f Summary of the content jetdieect the page No. To complete the print path setup, follow the instructions on the screen. Page 77 Table 7. These messages include configuration information and error messages for each network operating system. It also supports NetWare 4.
HP Jetdirect Configuration Page Messages Introduction This chapter describes the messages, network statistics, and status that can be printed on a Jetdirect configuration page. The name of the HP Jetdirect configuration file. Formore information, see Appendix A. Page Figure 6.